Difference between revisions of "Group 1 - MAKE - Claudio"
From Hackteria Wiki
(→MAKE - Claudio) |
(→MAKE - Claudio) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
=== MAKE - Claudio === | === MAKE - Claudio === | ||
Making our own printed circuit board | Making our own printed circuit board | ||
| + | The first step was to get the circute from the foile with UV light onto the print. (60 seconds under the “nail-studio” UV light) | ||
| − | + | [[File:2015-04-25 13.26.36.jpg|400px]] | |
| − | [[ | + | [[File:2015-04-25 13.26.48.jpg|400px]] |
| − | [[ | ||
The second step was to remove the unnecessary copper. This was done with different acids. | The second step was to remove the unnecessary copper. This was done with different acids. | ||
| − | [[ | + | |
| + | [[File:2015-04-25 13.26.27.jpg|400px]] | ||
After that the circuit was soldered. (Components: microcontroller, capacity, LED, speaker) | After that the circuit was soldered. (Components: microcontroller, capacity, LED, speaker) | ||
| − | [[ | + | |
| + | [[File:2015-04-25 13.24.55.jpg|400px]] | ||
Latest revision as of 20:01, 25 April 2015
MAKE - Claudio
Making our own printed circuit board The first step was to get the circute from the foile with UV light onto the print. (60 seconds under the “nail-studio” UV light)
The second step was to remove the unnecessary copper. This was done with different acids.
After that the circuit was soldered. (Components: microcontroller, capacity, LED, speaker)
