Difference between revisions of "Group 1 - MAKE - Claudio"
From Hackteria Wiki
(Created page with "=== MAKE - Claudio === Making our own printed circuit board The first step was to get the circute from the foile with UV light onto the print. (60 seconds under the “nail-s...") |
(→MAKE - Claudio) |
||
| Line 3: | Line 3: | ||
The first step was to get the circute from the foile with UV light onto the print. (60 seconds under the “nail-studio” UV light) | The first step was to get the circute from the foile with UV light onto the print. (60 seconds under the “nail-studio” UV light) | ||
| + | [[:File:2015-04-25 13.26.36.jpg]] | ||
| + | [[:File:2015-04-25 13.26.48.jpg]] | ||
| + | |||
| + | The second step was to remove the unnecessary copper. This was done with different acids. | ||
| + | [[:File:2015-04-25 13.26.27.jpg]] | ||
| + | |||
| + | After that the circuit was soldered. (Components: microcontroller, capacity, LED, speaker) | ||
| + | [[:File:2015-04-25 13.24.55.jpg]] | ||
Revision as of 19:56, 25 April 2015
MAKE - Claudio
Making our own printed circuit board
The first step was to get the circute from the foile with UV light onto the print. (60 seconds under the “nail-studio” UV light) File:2015-04-25 13.26.36.jpg File:2015-04-25 13.26.48.jpg
The second step was to remove the unnecessary copper. This was done with different acids. File:2015-04-25 13.26.27.jpg
After that the circuit was soldered. (Components: microcontroller, capacity, LED, speaker) File:2015-04-25 13.24.55.jpg
